PhaseOne iXM-GS120 - Interpreting Camera Status LEDs; Temperature Warning Indicators

iXM-GS120 Operation Guide
13. Interpreting the Camera LEDs
Page 32 of
32
13 Interpreting the Camera LEDs
The camera back has three LEDs that indicate camera status as follows:
13.1 Temperature Warning
When working continuously for an extended period, such as in HDMI mode or when rapid capturing, the camera internal
temperature may exceed its upper limit. Temperature states are indicated by the Operation LED as follows:
State
Indication
Temperature High
Operation LED flashes green slowly (regular mode).
Operation LED flashes blue slowly (Live View or HDMI modes).
Temperature Very High
Operation LED flashes green quickly (regular mode).
Operation LED flashes blue quickly (Live View or HDMI modes).
Thermal Shutdown
Operation LED flashes red quickly.
Location in
Figure Above
LED Off Green Blue Orange Red
1
Storage
No storage
Storage available
-
Storing
-
2
Operation
-
Ready
Live View/
HDMI modes
Capturing
Not ready
3
Power
No power
Power on
-
Starting-up
-
Note
Thermal shutdown stops all active capturing:
• All unsaved images are lost.
• If the temperature falls below the thermal shutdown level, capturing restarts and works normally.