PhaseOne iXM-GS120 - Control Cable Pinout and Signals

iXM-GS120 Operation Guide
4. Cable Specifications
Page 12 of
32
4.2 Control Cable
The control cable open end is connected to your system through nine (28 AWG) wires, and the LEMO connector end is connected
to the camera center or left LEMO (data) port, depending on your system configuration.
The following figures and table show the cable pinout and signals.
Control Cable Plug Pinout
Camera Socket Pinout
Control Cable Signals
Pin Color Name Description Direction
Parameter Voltage
Levels
(see next table)
Notes
1
Orange
Reserved
Reserved
Reserved
Reserved
Reserved
2
Green
System Ready
iXM-GS120 ready for
next capture.
Out
VOH, min = 4.0V
(Io = -10uA)
VOL, max = 0.8V
(Io = 4mA)
5 V level pull up resistor
47.5K Ohms to +5 V
3
Red
Black Reference/
Wakeup Control
Indicates a black
reference sequence is
required.
In
VIH, min = 2.4V
VIL, max = 0.8V
tiF, tiR < 1uSec
Isolated. Active low. For black
reference, see Section 3.2 Black
Reference