PhaseOne iXM-GS120 - Setting When Low Power Mode is Activated; Restoring Default Camera Values

iXM-GS120 Operation Guide
11. Miscellaneous Camera Settings
Page 29 of
32
11.5 Setting When Low Power Mode is Activated
To set when Low Power Mode is activated:
1. Click SETTINGS.
2. Click the required camera tab.
3. Click SERVICE.
4. Set the required LOW POWER MODE.
This is the time that, after the last operation, the camera reverts to low power mode.
11.6 Restoring Default Camera Values
To restore default camera values:
1. Click SETTINGS.
2. Click the required camera tab.
3. Click SERVICE.
4. Click RESTORE TO DEFAULTS.
Note
By default, the Network and custom White Balance parameters are not restored to camera defaults. However, in IX Capture,
you can manually add these parameters to be included when restoring.