PhaseOne iXM-GS120 - Dismounting a RSM Lens; Mounting a RS Lens

iXM-GS120 Operation Guide
6. Preparing the Camera
Page 17 of
32
6.2 Dismounting a RSM Lens
To dismount a lens from an iXM:
1. Use a 2 mm hex key to unscrew the four screws on the iXM camera.
2. Hold the lens and gently pull up at an angle.
6.3 Mounting a RS Lens
To mount an RS lens on the camera:
1. Remove the rear lens cap.
2. Hold the RS lens so that the lens contacts strip is above the RS adaptor contacts.
3. Slowly lower the lens opening onto the RS adaptor opening (opening -to-opening).
4. Use a 2 mm hex key to secure the lens assembly onto the RS adaptor by gently tightening each of the three locking screws.
5. Tighten the 3 locking screws a second time using a torque of 50 cNm.