PhaseOne iXM-GS120 - Preparing the Camera for Use; Mounting an RSM Lens

iXM-GS120 Operation Guide
6. Preparing the Camera
Page 15 of
32
6 Preparing the Camera
6.1 Mounting an RSM Lens
To mount a lens on a camera:
1. Place the camera interface with the sensor facing up and the camera contacts (solid blue) closest to you.
Camera Interface
2. Hold the RSM lens so that the lens contacts (solid green) are aligned with the camera contacts (solid blue).
RSM Lens
3. Place the lens groove on the camera ridge (opening-to-opening).
Note
• Before mounting or dismounting a lens, verify that the power cable is not attached to the camera.
• Mount/dismount lenses only in a clean environment.
• Place a soft cloth on the table to avoid scratching the camera.
• Place a lens cap on the lens.
Lens groove
Lens contacts
Camera ridge
Camera contacts