EN - 8
08/2012Copyright © 2012, Fast ČR, a. s.
How to disconnect the water supply hose?
Shut o the water inlet.
Reduce water pressure by pressing the reduce pressure button. This will reduce the water pressure and
prevent water from possibly squirting out into the room.
Unscrew the water supply hose from the water tap.
WARNING!
To prevent water from staying in the hose, close the water inlet into the dishwasher.
(This does not apply to dishwashers with the aqua-stop function.)
Connecting the drain hose
Insert the drain hose into the waste water pipe with a minimum diameter of 4 cm or leave it
lying in the sink and ensure that it is not bent or dented. Use a special plastic bracket supplied
with the appliance. The hose must be at a height of 50 to 110 cm above the ground. The loose end of the hose
must not be submerged in water so that reverse water ow does not occur.
NOTE:
The hose must be at a height of 50 to 110 cm above the ground. The loose end must not be submerged
in water.
To Next Page
Loading...
