EN - 7
08/2012Copyright © 2012, Fast ČR, a. s.
Electrical connection
Check that the voltage and frequency of the used power source correspond to the information on the
appliance's rating label. Insert the power plug only into a properly grounded power socket. If the socket to
which the appliance will be connected is not properly grounded, replace the socket rather than using adapters,
etc., which could lead to overheating or burning.
WARNING!
The incorrect connection of the grounding conductor may create a risk of injury by electrical shock.
If you have any doubts about the proper grounding of the appliance, ask a quali ed electrician
or service technician for veri cation.
Do not modify the power plug supplied with the appliance. If the power plug does not correctly
t into your power socket, ask a quali ed electrician to replace it.
Water supply
How to connect the water supply hose?
You must connect the dishwasher to a water supply using a new hose. Do not use perished, old or otherwise
damaged hoses.
Water pressure must be in the range 0.03 MPa to 1 MPa. If the water pressure in your system is lower, ask for
advice from our service department.
Pull out the hose fully from the storage area in the rear part of the dishwasher.
Screw in the water supply hose to a tap with a 3/4" thread.
Fully open the water supply before turning on the dishwasher.
Water supply hose
The water supply hose has double wall. The water lling system guarantees intervention by blocking the water
supply in the event that the water supply hose fails.
WARNING!
The hose connected to the water supply to the sink may break, if the sink is connected to the same
water system as the dishwasher. We recommend that you disconnect the hose and seal the opening.
To Next Page
Loading...
