EN - 28
08/2012Copyright © 2012, Fast ČR, a. s.
1. To remove and clean the ltration system turn the lter anticlockwise and then lift it up.
2. Pull out the metal/plastic lter.
3. Take the course lter out of the ne lter.
NOTE:
Follow all the steps of this procedure remove the ltration system; then reinstall it by proceeding from
step 3 to step 1.
Recommendation:
After every use of the dishwasher check that the lters are not clogged.
You can take out the ltration system by unscrewing the coarse lter. Remove any food remains
and clean out the lters under running water.
NOTE:
You should clean the entire ltration set once per week.
Cleaning the lters
To clean the coarse and ne lters use a brush. Reassemble the individual parts of the lter as shown on
pictures 1, 2 and 3. Reinsert them back into the dishwasher in their place and press them downwards.
WARNING!
Do not knock on the lters when cleaning them. Otherwise the lters could bend, which would
lower the e ciency of the dishwasher. Never use the dishwasher without a lter. An incorrectly
seated lter may lower the e ciency of the dishwasher and cause damage to dishes.
Dishwasher care
You can clean the control panel using a light damp wiping cloth. Thoroughly dry the area after cleaning.
Clean the exterior parts of the dishwasher using a quality polish.
Never use any sharp items, steel wool or coarse, sandy cleaning products to clean any part of the dishwasher.
To Next Page
Loading...
