Philco PDA 1291 BIT - Page 34

EN - 32
08/2012Copyright © 2012, Fast ČR, a. s.
Noise
Problem Possible causes What to do
Banging noise is
coming from the
dishwasher.
The spraying
arm is hitting some
dishes located in a rack.
Interrupt the program and rearrange the dishes, so
that they no longer interfere.
The dishwasher
coming from the
dishwasher.
Dishes are placed
loosely in the
dishwasher.
Interrupt the program and rearrange the dishes.
Knocking noise
coming from the
hoses.
This may be
caused by the installa-
tion or diameter of the
hoses.
This has no a ect on the operation
of the dishwasher.
If in doubt contact an authorised service centre.
The results
of the wash
are not
satisfactory.
The dishes are not
clean.
The dishes were not
loaded into the dish-
washer correctly.
See chapter "Washing dishes / cutlery".
The program was not
su ciently
intensive.
Select a more intensive program.
See "Program table".
Insu cient amount of
dishwashing detergent.
Use more dishwashing detergent
or use a di erent one.
Dishes are blocking the
spraying arms.
Rearrange the dishes so that the
spraying arms can rotate freely.
The  lters on the
bottom of the
dishwasher are not
clean or correctly
installed.
This may cause the
spraying arm jets
to become clogged.
Clean the  lter or install them properly.
Clean out the spraying arms.
See "Cleaning the spraying arms".
There is rust on
glass.
Combination of soft
water and an excessive
dose of dishwashing
detergent.
If you have soft water, for cleaning and
washing glass use less dishwashing
detergent and a shorter cycle.
Black or brown
stains on plates
Aluminium dishes were
leaning against the
plates.
Remove these stains using a gentle cleaning agent.
Dishwashing
detergent
remained in the
compartment.
The dishes blocked the
lid of the compartment.
Rearrange the dishes in the dishwasher.