DWhen you are recording, the red recording light at
the front panel of the TV-VIDEO Combi will be lit.
f Confirm with the OK button when the information is
correct.
E ’Press STANDBY to start recording’
will appear in the display. If the programmed recording
should start within the next few minutes, press
STANDBY m . If the programmed recording should start at
a later point in time, press the OK button.
DA programmed recording can only start when the
machine is switched to standby.
DIf you entered the wrong date for a daily/weekly
recording, your TV-VIDEO Combi will correct it
automatically.
g If you have confirmed with the OK button, use the
TIMER s button to exit the menu.
DThe programming information has been stored in a
TIMER block.
h Make sure that the cassette you have put in can be
recorded on.
How to check or change a TIMER
a Press the TIMER s button on the remote control.
b Select the line ’TIMER PROGRAMMING’ with the
menu buttons BP r or AP q and confirm with the
SqC button.
c Select the TIMER you want to check or change with the
BP r or AP q button and confirm with the OK
button.
d Select the entry field with the DSr or SqC
button.
e Change any information with the BP r or AP q
button or with the 0-9 buttons.
DUnder ’LP’, use the BP r or AP q button to
select the recording speed ’SP’ or ’LP’.
f Confirm with the OK button.
g To end, press the TIMER s button.
h Make sure that the cassette you have put in can be
recorded on.
How to clear a TIMER
a Press the TIMER s button on the remote control.
b Select the line ’TIMER PROGRAMMING’ with the
menu buttons BP r or AP q and confirm with the
SqC button.
c Select the TIMER you want to clear with the menu
buttons BP r or AP q .
d Press the CLEAR button.
e Switch off with the TIMER s button.
19
To Next Page
Loading...
