Philips 191E2SB/00 - Ambient Temperature: 0 C - 40 C; Electrical Characteristics; Interface; Interface Signals

Meridian 2
97
2.2 Scanning frequencies
Hor. : 30 - 83 K Hz
Ver. : 56 - 76 Hz
Video dot rate : <140 MHz
Power input : 90-264 V AC, 50/60 r 2 Hz
Power consumption : <16.6W (typ.), < TBDW (max)
EPA 5.0 TBD WATT
Functions:
(1) D-SUB analog R/G/B separate inputs, H/V sync separated, Composite (H+V) TTL level, SOG sync
(2) (2) DVI digital Panel Link TMDS inputs
2.3 Ambient temperature: 0
q
C - 40
q
C
3. Electrical Characteristics
3.1 Interface signals
1). D-Sub Analog
Input signal : Video, Hsync, Vsync
Video : 0.7 Vp-p, input impedance, 75 ohm @DC
Sync. : Separate sync TTL level, input impedance 2.2k ohm terminate
Hsync Positive/Negative
Vsync Positive/Negative
Composite sync TTL level, input impedance 2.2k ohm terminate (Positive/Negative)
Sync on green video 0.3 Vp-p Negative (Video 0.7 Vp-p Positive)
2) DVI-D Digital
Input signal : Single TMDS link (Three channels: RX0-/+, RX1-/+, RX2-/+)
3) Audio
Input signal: 1000 mVrms
Loudspeaker (Impedance: 8 Ohm +/-15%): 1.5 W+1.5 W stereo for RMS Power
Frequency range: 450Hz - 20 KHz
3.2 Interface
3.2.1 D-Sub Cable
Length : 1.8 M +/- 50 mm
Fix with monitor when packing, with transplant pin protective cover.
Connector type : D-Sub male with DDC2B pin assignments.
Blue connector thumb-operated jack screws
Pin assignments:
PIN No.
Description
PIN No.
Description
1 Red 9 DDC +3.3V or +5V
2 Green/ SOG 10 Logic GND
3 Blue 11 Sense (GND)
4 Sense (GND) 12 Bi-directional data
5 Cable Detect (GND) 13 H/H+V sync
6 Red GND 14 V-sync
7 Green GND 15 Data clock
8 Blue GND