2.1.6 PSTN dial-in connection
1. Connect a PSTN modem to the NetCam’s RS232 serial port.
2. Ensure that the modem is selected as connected device in the Serial
Configuration screen of the Administrator’s pages.
3. On the client side use a recommended browser with dial-up connection.
4. In the dial screen enter username/password of the NetCam. (default is guest
or admin).
5. To view the NetCam pages enter IP address 10.0.0.10 in the address bar.
2.1.7 Location
• Place NetCam2 appropriately for your purpose.
Caution: Do not expose the camera lens to direct sunlight. When operating
NetCam2 in outdoor light, an auto iris lens is recommended.
2.2 Installing NetCam2 Setup program
• Insert the software CD-ROM (supplied) into the drive.
• Copy ‘NetCamSetup.exe’ to the PC’s desktop.
• Double click on ‘NetCamSetup.exe’ to activate the setup program.
• Follow the screen instructions.
13
NetCam2 Section 2
To Next Page
Loading...
