Philips 22PFL3606 - Use Philips Easylink

33
English
Use Philips EasyLink
Get the most out of your HDMI-Consumer
Electronic Control (CEC) compliant devices
with Philips EasyLink enhanced control features.
If your HDMI-CEC compliant devices are
connected through HDMI, you can control
them at the same time with your TV remote
control.
To enable Philips EasyLink, you need to:
• Connect at least two HDMI-CEC
compliant devices through HDMI
• Congure each HDMI-CEC compliant
device properly
• Switch on EasyLink
Note
•
The EasyLink-compliant device must be switched on
and selected as the source.
• Philips does not guarantee 100% interoperability with
all HDMI CEC devices.
Switch on or off EasyLink
When you play a HDMI-CEC compliant device,
the TV switches on from standby, and switches
to the correct source.
Note
•
If you do not intend to use Philips EasyLink, switch it off.
1 Press .
2 Select [Setup] > [TV settings] >
[EasyLink].
3 Select [On] or [Off], then press OK.
• DVI-HDMI cable
• HDMI cable and HDMI-DVI adaptor
• VGA cable
DVI
PC IN
AUDIO
DVI
PC IN
AUDIO
VGA
AUDIOVGA
PC IN
EN