244E2 24” Wide FHD LCD Monitor
2010/05/16 PHILIPS 22 of 36
72 244E2 LCD
General Product Specification
ii. The OSD word color is white with transparent background.
iii. The demo profile will be “Video Playback” profile with “High” ODC setting.
C. Hot keys to trigger:
Press [Smart Image] 3 seconds or more to trigger the demo mode.
When demo mode is On, press 3 seconds or more to turn off the demo mode.
3.14.2
˦˴ʳ˸˸ʳʻ˸ʳ˷˼˸ʼʳˮʳˡ˂˔ʳ˼ʳ˅ˇˇ˘˅˰ʳ
Response time < 2 msec GtG (Typical),
ʳ
Unless otherwise specified, this specification is defined under the following conditions.
(1) Input signal : As defined in 3.3, 1920x1080
non-interlaced mode (1920X1080@60Hz 148.5MHz), signal
sources must have 75 ohm output impedance.
(2) Luminance setting : controls to be set to 250 nits with
full screen 100 % duty cycle white signal
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 ± 5 qC
4.2 Brightness
Follow Panel specification.
4.3 Image size
Actual display size 473.76 mm x 296.1 mm
4.4 Brightness uniformity
Set contrast at 100% and turn the brightness to get average above 300 nits
at centre of the screen.
To Next Page
Loading...
