Philips 32HFL4373D/10 - Page 25

PrimeSuite xxHFL4373D/10 Page 25
[Vsecure self test]
[Action] Internal self test to validate VSecure.
After this load proper hotel specific
keys.
[Program Info]
This function is to set the necessary DVB
parameters to locate the proper VSecure RF
channel to load the VSecure RF Static or RF
Dynamic key(s):
[Frequency] Frequency of MUX (0362)
[Medium] Cable or Antenna (DVB T)
[Service ID] # # # # # (00001)
[ONID] # # # # # (00000)
[NID] # # # # # (00000)
[TSID] # # # # # (00000)
[Symbol Rate] # . # # # (6.900)
[Modulation] QAM16, QAM32, QAM64,
QAM128, QAM256
Above parameters must match head-end
configuration
[Erase key option]
This function is to set the stored VSecure
Unprotect key(s) to erase:
[Shared key] Erase the Shared key
[Odd key] Erase the Odd key
[Even key] Erase the Even key
[All keys] Erase the Shared, Odd and
Even keys
[Erase key option]
This function is erase the key that were selected
by the Erase key option:
[Action] Press ‘>’ or ‘OK’ to erase the
key(s).
[Speaker settings]
This function defines the simultaneously working of
the integrated main speakers and the
headphone/bathroom speaker:
[TV Speaker Enable]
[Off]: The main speakers are muted.
The RC can control the volume and
mute of the headphone/bathroom
speaker
[On]: The main speakers are active and the
behavior of the headphone/bathroom
speaker is defined by the Independent
Main Speaker Mute.
[EasyLink]: xxxx
[EasyLink autostart]: xxx
[Independent Main Speaker Mute]
[Off]: The RC volume and mute will control
the main speakers and headphone /
bathroom speaker simultaneously.
[On]: If the main speakers are muted by the
RC, the RC will control the volume of
the headphone/bathroom speaker
[Default Main Speaker Volume]
This option defines the volume level that will be
set to the main speakers when the TV is
unmuted and the Independent Main Speaker
Mute is set to ‘On’.
[Factory default]
Restore the factory picture and sound setting.
Channel installation is not changed.