Philips 32HFL4373D/10 - Page 29

PrimeSuite xxHFL4373D/10 Page 29
Reinstall TV
Starts a TV initialization to reset all settings to
default and replace (reinstall) all channels.
1 Press [Home/Menu] ] > [TV Setup>
[OK].
2 Select [Setup] > [TV settings] >
[Reinstall TV], then press OK.
TV will perform a power down cycle going into
standby and then starts-up again. If the TV
stays in Standby mode, wake TV up with
switch on button on remote control.
1 Region OSD is displayed:
Region Australia
Europe
Select [Europe] and press <OK>.
2 Select language OSD is displayed:
Select [xxxx]
(i.e. language from list) and press
<OK>.
3 Select install country OSD is displayed:
Select [xxxx]
(i.e. country from list) and press
<OK>.
4 Select TV placement OSD is displayed:
[Wall mounted]: in case of wall
mounting
[On a TV stand]: in case of stand
and press <OK>.
5 Select TV location OSD is displayed:
[Home]: Always select this
[Shop]: Shop mode, not to be used
and press <OK>.
6 Universal access for the visual and
hearing impaired OSD is displayed:
[No]: No special settings
[Yes]: Special settings configured
and press <OK>.
7 Press [Settings] to continue and install
channels.
Perform the following steps:
[Install TV channels] and press <OK>
[Continue]
[Settings]
A screen is displayed to make changes to set
the channel list/map configuration:
[Symbol rate mode]: Automatic
TV will use the preset
Symbol rate (6.900/6.875)
Manual
Option to set Symbol rate 1
and Symbol rate 2
[Symbol rate 1]: 0.000 (to set)
[Symbol rate 2]: 0.000 (to set)
[Frequency scan]: Quick scan
Install channels based on a
pre-configured data table
Full scan
Install channels based on
scanning the whole
frequency spectrum
[Frequency step]: 1 MHz
With Full scan, step size to
search for channels is 1 MHz
8 MHz
With Full scan, step size to
search for channels is 8 MHz
[Network Frequency Mode]: Automatic
TV will set the Network
frequency based on a pre-
configured data table
Manual
Option to set Network
frequency
[Network Frequency]: 000.00 (to set)
[Analogue channels]: On
TV will scan also analogue
channels
Off
TV will not scan analogue
channels
[LCN Sorting]: On
TV will scan also analogue
channels
Off
TV will not scan analogue
channels
[Reset]: On
[Done]: Once finished select
[Done] and press <OK>