7 Install Channels
The first time you setup yourT_, you are prompted to select a menu
language and to install]_ and digital radio channels (if available),This
chapter provides instructions on how to reinstall and fine-tune channels.
SelectYour Menu Language
1 Press MENU on the remote control and select [LANGUAGE],
pH LipS
2
3
Press OK to start the installation.
Ifyou run [Autoprogram] when you have locked channels, a
message appears asking to enter your PIN. Enter your PIN in
order to complete the installation.
If you have forgotten your PIN, reset it as described in 'Change
your PlN'on page 19.
Select [Antenna] or [Cable] and press OK.
• When [Antenna] is selected, theTV detects antenna signals. It
searches for NTSC and ATSC channels available in your area.
• When [Cable] is selected,theT¢ detects signals supplied by
cable. It searches for NTSC,ATSC, and QAiVl modulated
channels available in your area.
2 Select a language and press OK to confirm your choice.
3 Press MENU to exit,
SetYour Location to Home
You can set the location ofyourTV to [Home] or [Retail].
Choosing Home gives you fuUflexibility to change predefined settings for
picture and sound.
t Press MENU on the remote control and select [FEATURES] >
[Location].
2 Select [Home] and press OK to confirm your choice.
3 Press MENU to exit.
Automatically Install Channels
Before you install channels, ensure that you are registered with your
cableTV provider and that your equipment is correctly connected,
t Press MENU on the remote control and select [SETUP] >
[Autoprogram].
*The illustration is discribed for 42PFL3704D.
• When autoprogramming is complete, the lowest memorized
channel will be displayed.
4 Follow the on-screen instructions to complete the installation.
Channel List
The channels selected here can be skipped when selecting the channels
using CH +/-.
Those channels can still be selected with the Number buttons.
t Press MENU on the remote control and select [SETUP] >
[Channel List].
24 EN
To Next Page
Loading...
