37
Computer connection issues
The computer display on the TV is not stable:
Check that your PC uses the supported •
resolution and refresh rate.
Set the TV picture format to unscaled.•
Contact us
If you cannot resolve your problem, refer to
the FAQs for this product at www.philips.
com/support.
If the problem remains unresolved, contact
Philips Consumer Care in your country as
listed in the Addendum.
Warning
Do not attempt to repair the product yourself. •
This may cause severe injury, irreparable
damage to your product or void your
warranty.
Note
Make a note of your TV model and serial •
number before you contact Philips. These
numbers are printed on the back of the TV
and on the packaging.
Sound issues
There is a picture but sound quality is poor:
Note
If no audio signal is detected, the TV •
automatically switches the audio output off
— this does not indicate malfunction.
Check that all cables are properly •
connected.
Check that the volume is not set to 0.•
Check that the sound is not muted.•
There is a picture but the sound quality is
poor:
Check that the sound settings are •
correctly set.
There is a picture but sound comes from one
speaker only:
Verify that sound balance is set to the •
centre.
HDMI connection issues
There are problems with HDMI devices:
Note that HDCP (High-bandwidth Digital •
Content Protection) support can delay
the time taken for a TV to display content
from a HDMI device.
If the TV does not recognize the HDMI •
device and no picture is displayed, try
switching the source from one device to
another and back again.
If there are intermittent sound •
disruptions, check that output settings
from the HDMI device are correct.
If you use an HDMI-to-DVI adapter •
or HDMI to DVI cable, check that an
additional audio cable is connected to
AUDIO L/R or AUDIO IN (mini-jack
only).
English
EN
To Next Page
