Philips 32PHA4509 - Changing Picture Format

English
11
EN
Summary of picture formats
Configuration of the picture setup listed below.
Notes
•
Some picture setups may be unavailable due to
differences between picture signal formats.
[16:9]: Change the normal
ratio to widescreen format.
[4:3]: The normal format.
[Zoom 1]: Horizontal
scaling of the widescreen
picture format. When this
format is used, the two
edges of the picture frame
will be partly cut off.
[Zoom 2]: Set the normal
ratio to widescreen format.
(PC mode only has options
for normal, widescreen and
Point to Point).
[Point to Point]: Used for
HDMI connections on PCs.
Will display the PC's full
screen in order to achieve
the best display effect.
•
[Sleep Timer]: Sets the duration the
TV remains idle before it automatically
enters standby mode. Adjust
the time with the sleep button
on the remote control. Options:
Off/10/20/30/60/90/120/180 minutes.
(Does not apply in PC mode)
.
•
[Power On Status]: Sets the TV
’
s status
when it is connected to an AC power
supply.
•
[Time Setup]: Sets the system time.
•
[Freeze Switch]: Sets the channel
freeze switch mode. (Only displayed in
TV mode)
•
[TTX Language]: Sets the TTX
language (Can only be used in TV
mode).
•
[Color System]: Sets the AV color
system. (Only displayed in AV mode)
•
[HDMI]: Sets the HDMI mode. (Only
displayed in 480p/576p/720p/1080p
HDMI modes.)
•
[Reset]: Restores the default setup.
(Excluding password setup and channel
information)
Changing picture format
1
Press ADJUST and select [Setup].
2
Press Select [Picture Format].
3
Select a picture format.
4
Press OK to confirm.