Philips 8000 Series - Unregister Handsets; Restore Default Settings

41EN
Auto registration
Extra handsets of the same model can be auto-
registered. Place the unregistered handset on
the base station.
» The handset detects the base station
and registers automatically.
» Registration is complete in less
than two minutes. The base station
automatically assigns a handset number
to the handset.
Manual registration/Pairing
If auto registration fails or if you register a
handset of a different model, register your
handset manually to the base station.
1 Select [Menu].
2 Press / to select , then press [OK]
to conrm.
3 Select [Register], then press [OK] to
conrm.
4 Press and hold on the base station for
5 seconds.
5 Enter the system PIN/passcode. Press
[Clear] to make corrections.
6 Press [OK] to conrm the PIN/passcode.
» Registration is complete in less than 2
minutes.
Note
• If the PIN/passcode is incorrect or no base is found
within a certain period, your handset displays a
notication message. Repeat the above procedure if
registration fails.
• The preset PIN/passcode is 0000. No change can be
made on it.
Unregister handsets
1 If two handsets share the same base
station, you can unregister a handset with
another handset.
2 Select [Menu].
3 Press / to select , then press [OK]
to conrm.
4 Select [Unregister], then press [OK] to
conrm.
5 Select the handset to be unregistered.
6 Press [OK] to conrm.
» The handset is unregistered.
Restore default settings
You can reset your phone settings to the
original factory settings.
1 Select [Menu].
2 Press / to select , then press [OK]
to conrm.
3 Select [Reset], then press [OK] to conrm.
» A conrmation request is displayed on
the handset.
4 Press [OK] to conrm.
» All settings are reset.