Philips AC3737/10 - Turning on and off; Water Level; Refilling Water

8 EN
Turningonando
Note:
•
For optimum purication performance, close doors and windows.
•
Keep curtains away from the air inlet or air outlet.
1 Put the plug of the appliance in the power socket.
2 Tap to switch on the appliance.
» The appliance beeps.
» The “ ” displays on the screen during warming up.
» In Purication ONLY mode, the screen shows PM2.5 level after
measuring the air quality.
» In 2-in-1 mode, the screen shows the current humidity.
3 Tap and hold the button for 3 seconds to switch o the appliance.
Note: If the appliance stays connected to the electrical outlet after turning
OFF, it will operate under the previous settings when turned ON again.
Waterlevel
If the water tank does not have enough water, the indicator will turn on, but the appliance will
continue to work and maintain the same fan speed. Once you add water to the tank, the indicator
will turn o.
Note: When the appliance is in Purication ONLY mode, it cannot humidify the air. As a result, the
indicator will not appear on the screen.
Rellingwater
Note:
•
Ensure the top lid is securely installed before relling the water tank.
•
Add water slowly to prevent splashing and avoid exceeding the maximum water level indicated on
the appliance.
The water tank can be relled in two ways: either directly without opening the top cover (Method A) or
by opening the cover and adding water through a tap (Method B).
•
MethodA:If using the direct rell method, monitor the water level through the transparent window
on the water tank to prevent overlling. Any excess water will be drained through the overow
outlet.
•
MethodB: If using the tap method, do not exceed the water level indication when adding water.
A
<40
B