Philips AC3737/10 - 4 Using the 2-In-1 Air Purifier&Humidifier; Switching the Working Mode

6 EN
4 Launch the “Air+” app and click on “ConnectaNewDevice” or press the “+” button on the top of
the screen. Follow the onscreen instructions to connect the appliance to your network.
Note:
•
This instruction is only valid when the appliance is being set up for the rst time. If the network has
changed or the setup needs to be performed again, see Chapter “Reset the Wi-Fi connection” on
page 6.
•
If you want to connect more than one appliance to your smartphone or tablet, you have to do this
one by one.
•
Make sure that the distance between your smartphone or tablet and the appliance is less than 10 m
without any obstructions.
ResettheWi-Ficonnection
Note:
•
Reset the Wi-Fi connection when your default network has changed.
1 Put the plug of the appliance in the power socket and tap to turn on the appliance.
2 Tap and hold and for 3 seconds until you hear a beep.
» The appliance goes to pairing mode.
» The Wi-Fi indicator blinks orange.
3 Follow the steps 3-4 in “SettinguptheWi-Ficonnectionforthersttime” section.
4 Usingthe2-in-1AirPurifier&Humidifier
Switchingtheworkingmode
Note: To rapidly improve the air quality, it's recommended to use the Purication ONLY mode.
The appliance has two working modes: 2-in-1 mode and Purication ONLY mode.
•
2-in-1 mode ( ):The water tank is correctly placed on the purier.
•
Purication ONLY mode: After removing the water tank, the appliance goes to the this mode
automatically.
Note: Once you have placed the water tank correctly, ensure that the transparent window of the water
tank is aligned with the display panel on the same side.