24 Maintenance
178
Monitor:
• There is no metal molded into the plastic parts and no metal sprays on the plastic.
• All plastic parts with a weight greater than 10g (0.35 ounces) are marked with the ISO code for
identification.
• You can disassemble the monitor as described in the Service Guide.
• The display has a touch resistor laminate.
• Recycle PCBs according to local laws.
• Recycle the paper Instructions for Use.
FM20/30
with
Battery
Option
#E25 Only
• The Lithium Ion battery should be removed and recycled according to local laws and regulations.
Transducer:
• The transducer housing is a two-component molding of polycarbonate (white) and polyurethane
(yellow) and has one brass thread-insert molded in.
• All labeling on the transducer has been done by laser, so no separation is necessary before
recycling.
• The housing is held together with screws.
• The transducer PCB is glued to the lower half of the transducer housing.
• Recycle the PCB according to local laws.
To Next Page
Loading...
