3 Basic Operation
45
8
Press the recorder Start/ Stop SmartKey or the Start Recordng SmartKey to switch on
the recorder.
9 Annotations of trace information are printed on the trace paper (see “Switching the Recorder On
and Off ” on page 49 for details).
Loading Paper: FM40/FM50
CAUTION
Using recorder paper that is not approved by Philips can result in accelerated paper fading and can
damage the thermal line printhead. This type of damage is not covered by warranty.
FM40/50 To load a pack of paper:
1 If the recorder is on, press the recorder Start/ Stop SmartKey or the Stop Recordng
SmartKey to turn it off before loading a new pack of paper.
2 Press the paper eject button to open the paper drawer.
3 Lift out any remaining paper from the tray. Press and hold the paper eject button to partially eject
the paper, thus making it easier to remove.
4 Hinge the transparent paper guide forward. It is held in the closed position by a small protrusion
on each side of the holder.
To Next Page
Loading...
