- 25 -
o If you don’t press “OK” once processing is done, the TV will go to standby after 30
minutes. You can press “OK” to close the overview screen, the installation is done and
you can start using the TV.
If a clone file and/or software is sent out over IP or RF the same process will happen automatically.
5.2 Settings during virgin installation
When you follow the Initial Setup wizard, you will be able to set the monitor to PRESENTATION
MODE with YES” or “NO”.
The differences of the setting PRESENTATION MODE “YES” or “NO” are:
Note: all settings, independent from the selection made during Initial Setup, can be changed later at
any time manually in the Professional Menu.
Disclaimer: Settings for PRESENTATION MODE “YES” or “NO”, as mentioned above, can be changed
without further notice!
To Next Page
Loading...
