o Navigate to the [Picture] [Advanced]
[Picture clean] menu
o You will see below items:
o [Noise Reduction]: Noise reduction
filters out and reduces the image
noise, you can put this [Off],
[Minimum], [Medium] or [Maximum]
o [MPEG Artefact Reduction]: MPEG
artefact reduction smoothens the
digital transitions in the picture, you
can put this [Off], [Minimum],
[Medium] or [Maximum]
o Navigate to the [Sound] [Maximum
Volume] menu
o Set the maximum volume by changing
the slider value, this will be the maximum
volume that a guest can set on the TV
o Navigate to the [Sound] [Sound
Management] menu
o You will see below items:
o [TV Speakers]: You can set the TV to
play sound on TV using [On] or on the
connected audio system using
[Easylink Autostart] or you can disable
the speakers using [Off]
Note: The audio system (supporting
ARC) must be connected via HDMI
o [Headphone/Bathroom speakers]: No
audio will be played via the
Headphone/Bathroom speakers when
[Off], it will be heard when [On] and a
device is connected
o [Headphone/Bathroom Spk Fixed
Vol]: When [On], the volume level of
the Headphone/Bathroom speaker
will be fixed to the Switch on Setting
o [Headphone Detection]: When the
Headphone Detection is set to [On]
and the headphone is connected then
TV speakers shall be muted
automatically. When [Off], the guest
has to manually mute the TV speakers
To Next Page
Loading...
