- 30 -
6.2 Overview
o Navigate to the [Overview] menu
o Open this menu item
o You will get an overview screen with all
the settings that are set in the TV, this
overview can be used to see the settings
without having to navigate to all menu’s
separately
o Using the “arrow up/down” buttons you
can go to the other overview pages
Note: No value can be changed in these
screens
o Pressing “back” will exit this screen again
6.3 Upgrade and Clone
o Navigate to the [Upgrade and Clone]
menu
o You will see the screen on the left
Note: Cloning and upgrading over IP or RF
will happen automatically after the TV is in
standby for 5 minutes if [Auto Upgrade
and Clone] in the professional menu is set
to [On]. The cloning over IP will happen
depending on the polling frequency set in
CMND. It can also take longer depending
on some other settings
To Next Page
Loading...
