- 58 -
device is connected to the TV using
[Off] or enable via [On]
o [Fallback on HDMI Break-out]: If
HDMI Plug-in/out is enabled then the
TV will follow this setting when the
HDMI connection is broken and go
back to the [SwitchOnSettings] or go
back to the [Previous Application]
o Navigate to the [Easylink] menu
o You will see below items:
o [Easylink]: Disable all HDMI CEC
functionality via [Off] or enable via
[On]
o [EasyLink Break-in]: TV shall disable
auto tuning/switching to the
connected HDMI CEC enabled source
via [Off] or enable via [On] when
device is plugged or switched on
o [EasyLink Remote Control]: The keys
from your TV RC will not be
forwarded via CEC when [Off] or will
be forwarded when [On]
o [Easylink Application]: When [On],
then TV shall forward the “Menu” key
to the source if the device is HDMI
CEC enabled and supports RC pass
thru
Note: Above menus are only available
when [EasyLink] is set to [On]
o Navigate to the [HDMI Ultra HD] menu
Note: This menu is only available for the
xxHFL6014
o You will see below items:
o [HDMI1 & 2]: Select [Optimal] to
enable the highest quality HDMI
signal for 4K Ultra HD (4K60 4:4:4),
select [Standard] or [Off] if picture or
sound are distorted
o [HDMI 3]: select [Standard] or [Off] if
picture or sound are distorted
Note: [Standard] enables up to 2160p60
4:2:0, [Optimal] enables up to 2160p60
4:4:4 and [Off] enables up to 1080p60.
The list of sources is depending on the
hardware in relation to the screen size
and can be different from the screenshot
To Next Page
Loading...
