Philips BTM2056/96 - Other Features; Set the Alarm Timer; Set the Sleep Timer; Play from an External Device

13 EN
6 Other features
Set the alarm timer
This system can be used as an alarm timer.
You can select CD, FM tuner, or USB as alarm
source.
Note
•
Make sure that you have set the clock correctly.
1 In standby mode, press and hold TIMER
until [SET TIMER] (set timer) scrolls on the
display.
» [SELECT SOURCE] (select source) is
displayed.
2 Press SOURCE repeatedly or the source
selection buttons on the remote control to
select a source: disc, FM tuner, or USB.
3 Press TIMERtoconrm.
» The hour digits blink.
4 Press or to set the hour.
5 Press TIMERtoconrm.
» The minute digits blink.
6 Repeat steps 4-5 to set the minute and
alarm volume.
Tip
•
If the system is idle for 90 seconds, it exits alarm setting
mode automatically.
To activate or deactivate the alarm timer:
In standby mode, press TIMER repeatedly to
activate or deactivate the alarm.
»
appears when the alarm timer is activated.
Tip
•
If CD or USB is selected as alarm source, yet there
is no disc inserted or no USB connected, the system
switches to the tuner source automatically.
Set the sleep timer
Note
•
Make sure that you have set the clock correctly.
When the system is turned on, press SLEEP
repeatedly to select the sleep timer period
(in minutes).
» If the sleep timer is activated,
is displayed.
To deactivate the sleep timer:
Press SLEEP repeatedly until [OFF] (off) is
displayed.
Play from an external device
You can also listen to an external audio device
through this system.
1 Connect the audio cable (not supplied) to:
• the MP3 LINK socket (3.5mm) on the
system.
• the headphone socket on an external
device.
2 Press MP3 LINK to select the MP3 link
source.
MP3 LINK