Philips CEM2000 User Manual

14
To replace the remote control batteries:
1 Open the battery compartment.
2 Insert 1 CR2025 batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
Turn on
1
Press /OK/MUTE to turn on the unit.
To turn off the unit, press 
/OK/MUTE for 3 seconds.
Set clock
1
Press MENU.
2 Press or repeatedly until the
currently time is displayed.
3 Turn /OK/MUTE clockwise to set hour.
4 Press /OK/MUTEWRFRQÀUP
5 Turn /OK/MUTE anti-clockwise to set
minute.
6 Press /OK/MUTEWRFRQÀUP
View clock
1 Press and hold OPTIONS repeatedly
until the clock is displayed.
Attach the front panel
1 Attach the trim plate.
2 Insert the right side of the panel in the
chassis until it is correctly engaged.
3 Press the left side of the panel and point
the left hole at the left pillar.
4 Release the panel to engage the left side.
Install remote control battery
Caution
Risk of explosion! Keep batteries away from 
KHDWVXQVKLQHRUÀUH1HYHUGLVFDUGEDWWHULHV
LQÀUH
Risk of decreased battery life! Never mix

different brands or types of batteries.
Risk of product damage! When the remote

control is not used for long periods, remove
the batteries.
Perchlorate Material - special handling may

apply. See www.dtsc.ca.gov/hazardouswaste/
perchlorate.
)RUÀUVWWLPHXVH
1 Remove the protective tab to activate the
remote control battery.
EN

Philips CEM2000 Specifications

General

Brand	Philips
Model	CEM2000
Category	Car Receiver
Language	English