Philips DSC 950 - Mains Connection

| J KL MNO PQ
Q DSS LINK — output sockets for connecting two chains of MAINS CONNECTION
digital speakers (Philips DSS930) to your Digital System
Controller. Up to 12 speakers can be connected. R MAINS OUTLETS — switched mains outputs for connec-
® Each digital speaker can be configured fora speaker ting mains plugs from various units such as tuner, cassette
system (A, B or C) and for a channel (left, right, mono). deck, CD player, etc. (maximum capacity is 100 VW)
e Make sure that all speakers in one room have the same (not on all versions)
speaker system setting. This means that all soeakers in ¢:= Mains lead
Room 1 should be set to system A, all speakers in room 2
should be set to system B and all speakers in room 3
should be set to system C.
e Several speakers in one room can have the same channel
setting (e.g. two left and three right speakers).
« Make sure that an end plug is connected to the output of
the last speaker in the chain. (these plugs are delivered
with the Philips DSS 930)
e Always locate your DSC950 in the same room as speaker
system A.
Remark: Make sure that you also make the analog connec-
tions (not only digital/optical connections) in order to take full
benefit of all the possibilities of your Digital System Controller
After making all the necessary connections (some may not be
applicable for your system set-up), your system Is ready for
use. In the next chapter we will describe how to operate your
Further information can be found in the instructions tor use nef
of
your
DSS930.
Digital
System
Controller.