1.5. Dismantling of the Digital Board
1) Remove 4 screws to loosen the Digital Board 1003 as shown in Figure 9.
Figure 9 - Remove mounting screws for Digital Board
2) Service position for Digital Board is given in Figure 10. (Remove the Digital Board Bracket 187 and take
out the cables beneath it to make it easier to flip over the digital board. Front Panel should also be
removed. Flip over the digital board and put the insulation sheet under it for servicing)
Figure 10 - Digital Board Service Position (the Digital Board Bracket Removed, and Front Panel Detached)
Insulation
Sheet
Insulation
Sheet
To Next Page
Loading...
