Reference : SGP_AVS_SW_ATLAS-05-05 Classification : COMPANY RESTRICTED
Version : 0.17 Project : ATLAS_DSW
Status : Proposed Chapter : User Manual
Date : 2006-09-12
Section : Diagnostic Software (Leco+)
© Philips Electronics N.V. 2006 Philips Semiconductors Page 66 of 124
Nucleus Name
DS_SYS_BuildInfoGet
Nucleus Number 1236
Description Retrieve the software build information of the Diagnostics & Service application
Technical - Show the information that is stored in the DVDR_BuildInfoType structure
Execution Time Less than 1 second
User Input None
Error Number Description
123600 Retrieving build info succeeded
123601 Retrieving build info failed
Example
DS:> 1236
123600:
Version :1091
Build :20050823_0630
Release :SG1_1
Buildtype :dev
Baseline :SGP29atl#SG1_1_20050609_base
Variant :genlecoplus
Test OK @
1
Nucleus Name
DS_SYS_UartSetup
Nucleus Number 1237
Description Set up a configuration for the selected UART
Technical - Parse user input
- Use MIS_UART_Setup to setup the selected UART with the requested
parameters
Execution Time Less than 1 second
User Input The user inputs 6 parameters:
<UartNr><baudrate><flowcontrol><databits><parity><stopbits>
UartNr:
1=UART port 1 : not used (Chrysalis only)
2=UART port 2 : Bit Engine or DTTM (Chrysalis only)
3=UART port 3 : Analogue board
baudrate:
115200,62500,57600,38400,19200,9600,4800,2400,1200
flowcontrol:
0=disabled 1=enabled
databits:
7 or 8
parity:
“NO”, “ODD” or “EVEN”
stopbits:
1 or 2
Error Number Description
123700 Setting up the selected UART succeeded
123701 User provided Invalid setup parameters
123702 Setting up the selected UART Failed
123703 Selected UART is not available
Example (Chrysalis)
DS:> 1237 2 38400 0 8 NO 1
123700:
Test OK @
Example (Leco)
DS:> 1237 2 38400 0 8 NO 1
123703: The selected UART is not available
Error @
2
To Next Page
Loading...
