9
Press ACH+ or VCH- to select your Cable Box out-
put channel, then press OK.
If you used an RE coaxial cable to connect the Cable Box to
the DVD Recorder (as shown on page 2 of this Guide),
choose channel 2, 3, or 4. If you used Audio andVideo
cables as shown on page 3 of this Guide, choose EXT2. If
you connected the Cable Box to other jacks of the DVD
Recorder, select EXT 1, CAM 1, or CAM 2.
iDirections for connecting the G-Link cable will appear on
the TV screen. If you have not connected the G-Link
cable yet, do so now. Press OK when the G-Link cable is
connected and you are ready to continue. More connection
details are on pages 2-3 of this Guide.
_ A list of Cable Box brands will appear. Press ACH+ or
VCN- to select your Cable Box brand, then press
OK. If your brand is not listed, select "Not Listed."
You will be advised to turn on the Cable Box and set it
_to channel 2. After doing this, press OK to continue.
The DVD Recorder will start testing codes,which will allow
the G-Link cable to change the Cable Box to channel 9. A
message will ask you to confirm whether the Cable
Box has changed to channel 9. Press ACN+ to select
Yes if the Cable Box has changed to channel 9, then
press OK.
If the Cable Box does not changeto channel9, check all
connections.Then, press ACH+ or VCH- to select"Test
this code again;' then press OK. Or, press ACH+ or VCH-
to choose No, then press OK. The DVD Recorder will try
a different code.
Repeat this process as necessary until the Cable Box
changesto channel 9. Several codes may haveto be tested
before the correct one is found.
The GUIDE Plus+_ System settings will appear ("Confirming
_Your Settings"). If the settings are correct, press
&CH+ to choose "Yes, end setup," then press OK.
If the settings are incorrect,press VCH- to choose "No,
repeat setup process," then press OK.You will go through
the setup screens again. Change any incorrect information.
Helpful information about the GUIDE Plus+_'System will
appear.Press OK to continue.
Another message confirming completion of setup will
appear.Youwill be prompted to press OK to activate
"Watch T_" Press OK.You are finishe!!
Within a few seconds,the DVD Recorder will turn itselfoff,
then on again.
_ Press STANDBY © to turn off the DVD Recorder.
_The GUIDE Plus+® System programming informa-
tion will be available in about 24 hours. When the
Recorder is off, channels will changeon your Cable Box.
This is normal, asthe unit issearching for GUIDE Plus+_°
System information.For best results, turn off the DVD
Recorder overnight so it can receive the GUIDE Plus+_'
System programming information.Leave the Cable Box
turned on.
cb
T_MER n[C_O_ PtA¥_O_ _,S,DV0
Mor_OR _IM RtTuRr_
SU_T_LE _tJ_O _E ZOOM
_oOa
0 0 • 0
1 2 3
4 5 6
7 8 9
0
• You must connect the G-IJnk cable in order
to make programmed recordings with a
Cable Box. Otherwise, the DVD Recorder
cannot change channels at the Cable Box.
The wrong channel may record if you do
not use the G-Link cable.
• Remember, you cannot use the GUIDE
Plus+_'System if you connected the DVD
Recorder to a Satellite Receiver.
To Next Page
Loading...
