Philips EasyKey 9300 - Page 25

23
Triggering: After waking up, the system
will run an automatic examination on the
battery voltage. If the voltage is too low, the
lock will give an alarm with a voice prompt
of “Low battery voltage. Please replace all
batteries”.
Alarm mode: A voice prompt of “Low battery
voltage. Please replace all batteries” during
unlocking.
Turning o: The alarm will be automatically
turned o.
Low Battery Voltage Alarm reminds you of replacing the batteries in time
Triggering 1: The door is pried open and the
sensor latch bolt pops up.
Alarm mode: Continuously repeated alarms.
Turning o: The alarm can be turned o
automatically or by a successful verication.
Triggering 2: The door is pried open and
there is no close t in the door.
Alarm mode: Continuously repeated alarms.
Turning o: The alarm can be turned o
automatically, by a successful verication
from outside or normal unlocking from
inside.
Anti-dismantling Alarm
Triggering: The deadbolt works abnormally,
fails to lock or unlock the door.
Alarm mode: Continuously repeated alarms.
Turning o: The alarm will be automatically
turned o.
Deadbolt Abnormality Alarm