43
Temporany solutions
Cable tie for the pump
To make sure the pump won’t move from its place. The pump will be assembled with a cable tie. In case a
swap is needed, please follow these step to place it back:
1. Start inserting a cable tie (20cm x 1,2mm) in the empty space of the pump holder, then keeping both pull
them inside:
2. In pictures 1 and 2 you can see the exactly position where to place the cable tie.
3. Don’t close it too much: the leftover cable needs to be 5cm to guarantee the proper tightness (picture 3)
Functions/features explanation
To Next Page
Loading...
