English
10
Step 2: Connecting Speakers
● Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to “R” and left
speaker to “L”, coloured (marked) wire to “+”
and black (unmarked) wire to “–”. Fully insert the
stripped portion of the speaker wire into the
terminal as shown.
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Connections
Step 1: Placing speakers
For best possible surround sound, all speakers
(except subwoofer) should be placed at the
same distance from the listening position.
To avoid overheating of the system, a
safety circuit has been built in.
Therefore, your system may switch to
Standby mode automatically under
extreme conditions. If this happens, let
the system cool down before reusing it.
FWD397-98_UM ENG_0514 2008.5.14, 15:5310
To Next Page
Loading...
