11
English
Using component Video In jack (Pr Pb Y)
● Use the component video cables (red/blue/
green-not supplied) to connect the system’s PR
PB Y jacks to the corresponding Component
video input jacks (or labeled as Pr, Pb, Y or YUV)
on the TV set.
● To listen this system channels through TV , use
the audio cables (white/red) to connect AUX
IN (L/R) jacks to the corresponding AUDIO
OUT jacks on the TV set.
● If you are using a Progressive Scan TV set (TV
with Progressive Scan or ProScan capability),
activate the PROGRESSIVE SCAN function
through SETUP.
Connections
Step 3: Connecting TV set
IMPORTANT!
– You only need to make one video
connection from the following options ,
according to the capabilities of your TV
system.
– S-Video or Component Video
connection provides higher picture
quality.These options must be available on
your TV set.
– Connect the system directly to the TV
set.
Using Video In jack (CVBS)
● Use the composite video cable (yellow) to
connect the system’s VIDEO jack to the video
input jack (or labeled as A/V In, Video In,
Composite or Baseband) on the TV set.
Using LINE OUT jack (L/R)
● To listen this system channels through TV , use the
audio cables (white/red) to connect LINE OUT
(L/R) jacks to the corresponding AUDIO IN jacks
on the TV set.
OUT
Y
To Next Page
Loading...
