English
34
Changing tuning grid
In some countries (only applicable for certain
regions), this function can changes the
frequency steps between grid 9 and grid10,
the frequency step between adjacent channels in
the MW band is 9 kHz tuner mode, (10 kHz in
some areas). The preset frequency step in the
factory is 9 kHz.
1 Plug the AC power cord.
2 Press TUNER to select MW mode.
3 Press and hold 38 for more than 5 seconds on
the panel.
Note:
– All preset stations will be lost and need to be
reprogrammed.
Tuner Operations
Manual preset programming
1 Press TUNER repeatedly to select the desired
tuner band: FM or MW.
2 Press and hold SEARCH•TUNING 1 /
¡ on the system or on the remote control to
search a radio frequency.
3 Press PROGRAM.
➜ “PROG“ will display.
4 Press O / P or numeric keys (0-9) to
select the desired preset number.
5 After selecting an address number, press
PROGRAM again to store the radio station.
● Repeat steps 3-5 to store other preset radio
stations.
Note:
– If you attempt to store more than 40 preset
radio stations, “FULL” will be displayed.
- This until exits presetting mode if no button is
pressed within 20 seconds.
Selecting a preset radio station
● In tuner mode, press O / P or use the
numeric keys (0-9) to select the desired
preset number.
➜ The preset number and radio frequency
appear on the display panel.
Deleting a preset radio station
1 In TUNER mode, press O or P to select the
preset radio station to be erased.
2 Press and hold 7 on the system until
“DELETED” appears on the display panel.
➜ The current preset radio station will be
deleted.
➜ The rest of the preset radio stations will shift
up.
● Repeat steps 1-2 to erase other preset radio
stations.
FWD397-98_UM ENG_0514 2008.5.14, 15:5334
To Next Page
Loading...
