5 Apply some lubricant to the part shown in the gure.
6 Apply some lubricant on both sides of the lever in the brewing unit.
7 Follow steps 9 to 11 of ‘Cleaning the brewing unit’ to place the brewing
unit and the coffee grounds container back into the coffeemaker.
Adjusting the grinding degree
Over time the grinder may change to a coarser setting. It is recommended
to adjust the grinding degree when you notice this. These adjustments are
not required regularly.
1 Take the grinding degree adjustment tool out of the recess next to
the brewing unit.
2 Insert the lug on the broad end of the grinding degree next to the
cap of the grinding degree adjustment hole and press lightly. This
makes the cap open automatically.
3 Insert the narrow end of the grinding degree adjustment tool into
the grinding degree adjustment hole so that the opening in the tool
ts onto the pin located at the bottom of the hole.
4 For a coarser setting, push down and turn the grinding degree
adjustment tool clockwise. For a ner setting, push down and turn
the grinding degree adjustment tool anticlockwise.
Note: Turn the grinding degree adjustment tool one step clockwise or
anticlockwise at the time. Then brew 2 or 3 cups of coffee to establish if the
grinding degree has been adjusted to your satisfaction.
5 When you are satised with the grinding degree, remove the grinding
degree adjustment tool from the grinding degree adjustment hole,
close the cap and place the grinding degree adjustment tool back
into its recess.
ENGLISH 19
4203_000_7242_2_DFU-Luxury_A5_v1.indd 19 1/9/13 1:37 PM
To Next Page
Loading...
