7 Place a bowl with a capacity of 1.5 litres on the drip tray cover.
8 Press the 1-cup button and the 2-cup button simultaneously for
1 second to start the descaling procedure.
, The activity light and the CALC CLEAN light both ash slowly to
indicate that the descaling cycle has started.
, The water-descaling solution mixture comes out at intervals. The
coffeemaker stops descaling a few times to let the descaling solution act.
, When the water tank is empty, the descaling cycle is nished. The
activity light goes out, the CALC CLEAN light starts ashing quickly
and the ‘water tank empty’ light goes on. Continue with the rinsing
cycle.
Do not switch off the coffeemaker or interrupt the descaling cycle.
Note: If you switch off the coffeemaker during the descaling cycle, the CALC
CLEAN light starts ashing quickly when you switch on the coffeemaker. In
that case, you have to complete the whole descaling procedure from the start.
Rinsing cycle
1 Remove the water tank from the coffeemaker.
2 Rinse the water tank under the tap.
3 Fill the water tank with cold tap water up to the MAX indication and
slide the water tank back into the coffeemaker.
MAX
ENGLISH22
4203_000_7242_2_DFU-Luxury_A5_v1.indd 22 1/9/13 1:37 PM
To Next Page
Loading...
