7 Remove the drip tray, rinse it and place it back.
8 Reattach the classic milk frother.
9 Remove the water tank and rinse it.
10 Reinstall the Intenza+ water lter (if present).
11 Fill the water tank with fresh tap water up to the MAX indication
and slide the water tank back into the machine.
12 Press the on/off button to switch off the machine.
, When you switch the machine back on, it is ready for use again.
If you are unable to nish the descaling procedure
If the machine gets stuck in the descaling procedure, you can press the on/off
button.This allows you to complete the descaling procedure. Follow the steps
below to make sure your machine is ready to brew coffee again.
1 Press the espresso button and regular coffee button simultaneously
for approximately 5 seconds.
2 Remove the drip tray, rinse it and place it back.
3 Remove the water tank and rinse it.
4 Fill the water tank with fresh tap water up to the MAX indication
and slide the water tank back into the machine.
5 Press the espresso button and brew a cup of espresso.
Repeat this twice.
6 Turn the control dial to the hot water icon. Let hot water ow out
of the hot water/steam wand until the ‘water tank empty’ light lights
up continuously.
7 Remove the drip tray, rinse it and place it back.
8 Reattach the classic milk frother.
9 Remove the water tank and rinse it.
10 Reinstall the Intenza+ water lter (if present).
11 Fill the water tank with fresh tap water up to the MAX indication
and slide the water tank back into the machine.
12 Press the on/off button to switch off the machine.
, When you switch the machine back on, it is ready for use again.
5 sec
ENGLISH 23
To Next Page
Loading...
