42
ENGLISH
Descaling Phase
9
Press the “ ” button to start the descaling cycle.
YellowYellow
10
The machine will start dispensing the descaling solution at regular
intervals. The bar on the control panel shows the cycle progress. This
procedure takes approx. 20 minutes.
Note:
The descaling cycle may be paused by pressing the “ ” button. To resume
the cycle, press the “
” button again. This allows you to empty the container
or to leave the machine unattended for a short time.
Yellow
11
When this icon is displayed, the water tank is empty.
Red
12
Remove the water tank, rinse it and ll it with fresh water up to the
CALC CLEAN level. Put it back into the machine.
13
Empty the drip tray and place it back.
14
Empty the container and place it back under both the steam/hot water
wand and the co ee dispensing spout.
To Next Page
Loading...
