Philips HD8841/09 - Table of Contents

PHILIPS 4000
Table of contents Page
1. Introduction
1.1. General Information 1
1.2. Tecnical specication 1
1.3. Consumer Replaceable Parts (CRP) List 2
1.4 Specic tools and equipment 4
1.5. Material 4
1.6. Safety warnings 4
1.7. Water circuit diagram 5
1.8. Electrical diagram 6
1.9. Service POLICY grid as used for coee machine 7
1.10. Error codes 8
1.11. Internal machine parts 9
2. Technical specications
2.1. Specication for the measurement of the coee products
temperature.
1
2.2. Specication for the measurement of the Milk products
temperature.
2
2.3. Machine parameters and performance 4
3. Operating logic
3.1. Single microswitch gear motor 1
3.2. Temperature sensor (adjustment) 1
3.3. Coee grinder 230V 2
3.4.1. Autodose system description 230V 2
3.4.2. Coee lack detection and coee grinder blocked 3
3.5. Coee grinder 120V 3
3.6.1. Low bean level detection, dose quantity adjustment, cof-
fee grinder blocked
3
3.6.2. Dose self-learning (SAS) 4
3.7. Coee cycle 5
3.8. Milk Carafe (OTC version) 6
3.9. Water level detection (water tank) 6
3.10. Water lter HD models 7
3.11. Descaling request HD models 7
3.12. AquaClean water lter EP models 8
3.13. Descaling request EP models 8
Table of contents Page
4. Diagnostic mode
4.1. Test Mode. 1
4.2. SteamOut 7
5. Saeco Service Center
5.1. Saeco Service Center - Quick Start Guide 1
6. Machine Repair Flow
6.1. Repair Flow 1
7. Disassembly
7.1. Outer Shell 1
7.2. Coee grinder 2
7.3. Grinder blades 2
7.4. Coee grinder adjustment 3
7.5. Carafe connection and hot/Steam water dispenser
(Philips 4000 OTC)
4
7.6. Hot water dispenser (Philips 4000 AMF-CMF) 4
7.7. Central plate 4
7.8. Pin boiler 4
7.9. Gear motor 5
7.10. Pump 5
7.11. Flow-meter 6
7.12. Boiler 6
7.13 CPU board 6
7.14. Programming access for SSC (Saeco Service Center) 6
7.15. KYB interface and display 6
7.16. Fitting and removing Oetiker clamps 7