Philips HP L1502 - Warning Message

HP L1502
6
Go to cover page
Warning message table
Warning message table
BASIC OSD MODE CONFIGURATION
Mode Menu
Menu Level 1 Menu Level 2 Menu Level 3 Factory Reset
Brightness ADJ Scale Y (FD = 100)
Contrast ADJ Scale Y ( FD = 50)
Auto Adjustment Show “Adjusting… ” message Y(noFD)
Advanced Menu Refer to table 8
Exit
Item Attention Signals Display Time Condition
1 Input Signal out of Range see power saver table
2 No Input Signal see power saver table
3 Going to Sleep see power saver table
4 Adjusting… .. The Minus ( " - " ) button shall be a hot-key for the Auto-Adjustment process.
Menu button ( ), shall be hot-key for OSD Menu Exit
5 OSD Lockout 10secs Push menu key for 10 sec then display 10 sec WM “OSD Lockout”
6 Check Video Cable see power saver table
Power Saver table
Power Saver - On Power Saver - Off Note
Quit signal with cable 1. System blank and show WM 1. System blank and show
"Going to Sleep" 3 sec then sleep. moving WM "No Input Signal" always.
Disconnect cable 1. System blank and show 1. System blank and show
WM “Check Video Cable”10 WM “Check Video Cable”10
sec then moving about 50 sec. sec then moving always.
2. Show WM “Going to
Sleep” 3 sec then sleep.
3. If push any key in sleep
mode, then repeat item 1 to 2.
Out of range –1 1. System blank and show 1. System blank and show H<29.5 or
moving WM “Input Signal moving WM “Input Signal H>82.5 or
out of Range” 60 secs. Out of Range” always. V<49 or
2. Show WM “Going to V>87 or
Sleep” 3 sec then sleep. Vtotal>=1200
3. If push any key in sleep
mode, then repeat item 1to 2.
Out of range –2 1. Show moving WM 1. Show moving WM DownScaling
"Input Signal out of Range" 60 sec. “Input Signal out of Range”60 sec. Ex.
2. Menu key can active 2. Menu key can active 1280x1024
during moving WM and during moving WM and
operate OSD menu. operate OSD menu.
3. WM disappear if menu 3. WM disappear if menu
key push or after WM 60 sec. key push or after WM 60 sec.
Out of range –3 1. Show moving WM 1. Show moving WM 85Hz
"Input Signal out of Range" 60 sec. “Input Signal out of Range”60 sec.
2.AftermovingWM60sec 2.AftermovingWM60sec
then show WM “Going to Sleep”3 sec then show WM “Going to
then sleep. Sleep” 3 sec then sleep.
3. If push any key in sleep 3. If push any key in sleep
mode, then repeat item 1 to 2. mode, then repeat item 1 to 2.