11
Disassembling and cleaning before rstuse
1 Remove the mixing chamber lid. (Fig.3)
2 Loosen the front panel control knobs. (Fig.4)
Note: The front panel is heavy. Take extra caution when removing it.
3 Disassemble the front panel, the shaping disc, the shaping disc holder, the mixing paddle,
and the mixing chamber in order. (Fig.5)
4 Clean all detachable parts, and wipe them dry. (Fig.6)
5 Pull out the shaping disc storage drawer, and clean all discs and cleaning tools. (Fig.7)
Assembling
1 Push the mixing chamber into the appliance. (Fig.8)
2 Point the mixing paddle to the hole in the main unit. Insert the mixing paddle all the way
into the main unit. (Fig.9)
3 Attach the disc holder onto the appliance. (Fig.10)
4 Put the shaping disc onto the disc holder, and make sure it is rmly xed on the disc
holder. (Fig.11)
Note: Make sure the inner cavity of the shaping disc and disc holder is properly tted.
(Fig.12)
5 Attach the front panel to the main unit. (Fig.13)
Note: The front panel is heavy. Take extra caution when assembling it.
6 Fasten the front panel control knobs. (Fig.14)
Note:
y If the front panel or the shaping disc is not properly assembled, a safety switch will
prevent the appliance from working.
y Make sure the front panel is completely fastened before using the appliance.
7 Close the mixing chamber lid. (Fig. 21)
Using the Pasta maker
Start preparation
1 Put the plug in the power socket. The pasta maker sound once, and all indicators ash once.
(Fig.15)
Note: Make sure that all the parts are well assembled before plugging in.
2 Press the On/o button to turn on the appliance. (Fig.16)
3 Select the pasta type with the Program selection button. (Fig.17)
Tip:
y If you prepare a recipe with egg and water, crack the egg and put it as a whole in the
water cup and ll up with water to the needed amount.
y Instead of water you can also use veggie juices (e.g. spinach juice, beetroot juice, etc.).
To Next Page
Loading...
