Philips HTS9520 - Video and Audio Setting Adjustments

20
Set up network
1 Press (Home).
2 Select [Setup], then press OK.
3 Select [Network], then press OK.
4 Select and adjust the following settings:
• [Network Installation] : Starts wired
(Ethernet) or wireless setup. Follow
the instructions to set up the network
connection.
• [View Network Settings] : Displays
the current network settings.
• [View Wireless Settings] : Displays the
current Wi-Fi settings.
• [Net TV User Location] : Selects the
location for accessing Net TV content
and services.
• [Clear Net TV Memory] : Clears Net
TV memory, delete the temporary
downloaded les (e.g., cookies) of the
Net TV browser.
5 Press OK to conrm your choice.
Set up EasyLink
1 Press (Home).
2 Select [Setup], then press OK.
3 Select [EasyLink], then press OK.
4 Select and adjust the following settings:
• [EasyLink] : Enables or disables EasyLink.
• [One Touch Play] : Enables or disables
One Touch Play.
If enabled, you can use the remote
control to start disc play in the
home theater and the TV switches
automatically to the correct channel.
• [One Touch Standby] : Enables or
disables One Touch Standby.
If enabled, the home theater can
be switched off to standby by a
remote control from the TV or other
connected HDMI CEC devices.
• [System Audio Control] : Enables or
disables System audio control.
If enabled, follow the instructions on
the TV to map the connected devices
correctly to the audio connectors of
the home theater. The home theater
switches automatically to the audio
source of the connected device.
• [Blu-ray 3D video]: Selects the
3-dimensional video output when you
play a 3D video on your home theater.
The home theater must be connected
to a 3D TV through HDMI.
• [Picture Settings]: Selects a predened
color setting.
5 Press OK to conrm your choice.
Note
• The best setting is automatically selected for
the TV. If you change the setting, ensure that
the TV supports the new setting.
• For settings related to HDMI, the TV must be
connected through HDMI.
• For settings related to progressive or
component video, the TV must be connected
through Component Video.
Change audio settings
1 Press (Home).
2 Select [Setup], then press OK.
3 Select [Audio], then press OK.
4 Select and adjust the following settings:
• [Night Mode] : Selects quiet or full
dynamic sound. Night mode decreases
the volume of loud sounds and increases
the volume of soft sounds such as speech.
• [HDMI Audio] : Selects HDMI audio
format or disables HDMI audio output
for the TV.
• [360Sound Setup] : Basic 360Sound
setup. This only performs the acoustics
and rear speakers placement setup
which is the minimum requirement for
a 360Sound system.
• [Speaker Setup] : Sets the volume level
and distance of each speaker to obtain
the best possible surround sound
based on your room setup.
5 Press OK to conrm your choice.
Note
• For settings related to HDMI, the TV must be
connected through HDMI.
• Night mode is available for Dolby encoded
DVD and Blu-ray discs (for models support
Blu-ray playback).
EN