SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
Point to any of the luminaires in the
group, press “send.”
The luminaire will FLASH twice
and group light level will go to
50%.
If unsure about mode selection or remote blinking status then wait for the
remote blinking to stop and redo step “b.”
Point to any of the luminaires in the
group and press “lock.”
Wait for LED to stop blinking (apx. 10
seconds) then press “send.”
Red LED on remote will start
blinking.
The luminaire will FLASH twice.
Group is ready for normal
operation.
To Next Page
Loading...
