Philips IRT 9090/01 - Daylight Sensor Control

SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
20
10. Activate / Deactivate daylight sensor
Daylight sensor is active by default. Changes have to be performed on each luminaire
in the group.
a.
Point remote to any luminaire and press
“unlock,” once.
Wait for LED to stop blinking (apx. 10
seconds).
Point remote to any of the luminaires
and press “send.”
Red LED on remote will start
blinking.
Red LED on remote will stop
blinking.
The luminaire will FLASH twice
and group light level will go to
50%.
b.
Press “daylight” button.
While the LED is still blinking red, enter
the numbers:
“1”: Disable daylight sensing
“2”: Enable daylight sensing
Red LED on remote will start
blinking.
Red LED on remote will stop
blinking.