Philips IRT 9090/01 - Selecting Application Modes

SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
10
6. Application Mode Selection
a.
Point remote to any luminaire and press
“unlock,” once.
Wait for LED to stop blinking (apx. 10
seconds).
Point remote to any of the luminaires
and press “send.”
Red LED on remote will start
blinking.
Red LED on remote will stop
blinking.
The luminaire will FLASH twice
and group light level will go to
50%.
b.
Point to any of the luminaires in the
group and press “mode.”
While the LED is still blinking red, enter
the number for the preferred mode (see
list at step 5).
Eg. Select “8” for warehouse comfort
application mode.
Red LED on remote will start
blinking.
Red LED on remote will stop
blinking.